NZXT LEXS-001BK Bedienungsanleitung PDF herunterladen (Seite 7)

3. Connect the HDD LED (labeled H.D.D LED) and HDD LED

connectors to the appropriate headers on your motherboard.

(Red/White, +/-). The hard drive activity is displayed by the

front led under the Power LED. When your hard drive is

active, the blue LED should flash.

All White Pin Connectors correspond to ground.

LCD Temperature Display

Installing Temperature Sensors & Powering the Meter

Begin by connecting the 4 pin Molex connector coming from the

meter to the Power supply.

Remove the clear plastic tube surrounding the probe before installing.

Keep the orange protective that is on the sensor attached.

In order to attach the SENSOR wires, use the tape provided to

attach them to the appropriate locations marked on the wires. The

SYS sensor can be attached to your VGA card or an area near the

rear fan. The HDD sensor is used for the hard drive, and the CPU

meter for the CPU. Please following precautions when attaching the

probe to measure the CPU, do not tape the sensor on the micro

chip area.

From Left to Right. CPU, Hard Drive, System Temperature Display

NZXT. 7

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Keine Kommentare

NZXT LEXS-001BK Bedienungsanleitung Seite 7